Products

Standard Pen Point replacement for Oneway Live Centre 

  6 INCH FACEPLATES Our 6" Faceplates and larger, are constructed using cast iron. This enables us to re-enforce the outer diameter with a 1" wide...

Our spindle steady rest uses the same scissor action the bowl steady uses. This clamping method provides rock soild clamping with little or no flex...

  The No. 2 Patented Profiled Jaws (shown right-top) come standard on all our chucks. They have the mass and size necessary for medium sized bowls ...

  These jaws have the mass and size necessary for large bowls and vases. The profiled jaws provide maximum gripping power with minimal damage to th...

  These jaws are the largest of our top jaws. They have even more mass and size necessary for large bowls and vases. The profiled jaws provide maxi...

Never again will you feel like you need three hands to tighten your workpiece in a woodturning chuck! Using a unique chuck and key system, the Stro...

Flat Jaws are designed to accommodate custom wooden jaw sets for those odd shaped pieces or extremely delicate pieces where you do not want to dam...

 These jaws are aluminum plates machined from a solid (for greater strength).Their unique combination of slots and tapped holes for mounting the ru...

 These jaws are aluminum plates machined from a solid (for greater strength).Their unique combination of slots and tapped holes for mounting the ru...

 They are machined long and deep for better grip on smaller parts. The outside surface of the jaws is serrated to grip the work piece.These jaws ar...

This is the adapter that you must have to mount a Oneway Strong Hold Chuck on your lathe. Pick the one that matches your spindle size. 

Oneway, Chuck Key for Stronghold Chuck

 The No. 2 Patented Profiled Jaws (shown right-top) come standard on all our chucks. They have the mass and size necessary for medium sized bowls a...

 These jaws have the mass and size necessary for large bowls and vases. The profiled jaws provide maximum gripping power with minimal damage to the...

 This is the adapter that you must have to mount a Oneway Talon Chuck on your lathe. Pick the one that matches your spindle size. 

  The body diameter of this chuck is 3½" (slightly smaller than the original ONEWAY Chuck), however, the body design follows that of theSTRONGHOLD ...

  They are machined long and deep for better grip on smaller parts. The outside surface of the jaws is serrated to grip the work piece. These jaws...

 These jaws are aluminum plates machined from a solid (for greater strength).Their unique combination of slots and tapped holes for mounting the ru...

  The body diameter of this chuck is 3½" (slightly smaller than the original ONEWAY Chuck), however, the body design follows that of theSTRONGHOLD ...